1. The hot air inhaled by the blower is dispersed on the upper end of the heating cylinder, flows uniformly in the heating cylinder and conducts effective geothermal exchange with the heating tube. Then the hot air collects at the lower end of the heating cylinder, and enters the cylinder from the lower part through the screen separator.

2. The hot air uniformly diffuses upward, so that the mold particle raw materials in the barrel are continuously dried from the bottom to the top; After a certain period of drying, the raw materials below the drum can be evenly and fully dried, while the new materials above the drum can be continuously supplied, so as to make the raw materials automatically dry

。

1. Dehumidifying dryer is a special equipment for the plastic industry that can continuously deliver dry air. It is mainly inhaled moist wind through the molecular sieve drying effect and the output of dry wind.

2. And the characteristics of the molecular sieve is low moisture, high temperature platoon is wet, that is, inhalation of damp wind cooling processing first, and then water is molecular sieve (state) in low temperature adsorption, and molecular sieve inhalation moisture, we again for high temperature processing, make its water to the atmosphere, and constantly work cycles.

1. Set dehumidification drying and feeding in one. Not only can dehumidify and dry all kinds of plastic raw materials, but also can feed to injection molding machine and other molding host, to the greatest extent to solve the problem caused by plastic particles water absorption or water deposition.

2. Drying mode of circulating wind. According to the quality of raw materials, different varieties or the requirements of products, the SHY type dry blaster can choose to adjust the cycle switching time of dehumidifying molecular sieve tube, regenerative heating temperature and drying temperature of materials.

3. The cyclic wind mode operates in a closed air loop. After the particles are dried together, the air returns directly to the fan. オ only when feeding insufficient wind, outside air is inhaled to supplement the air volume, the maximum energy saving.

4.SHY type combined machine is operated by a control device with keys and LED display. The cycle switching time and regenerative heating temperature of dehumidifying zeolite can be adjusted. Separate configuration heating drying, feeding and other single control functions for easy operation.

1. Dehumidification drying feeder is a combination of dehumidification, drying and two-stage feeding, especially suitable for engineering plastic materials with strong hygroscopic properties.

(2) in plastic processing industry, the products are shrinking, silver lines and bubbles, cracks, flow mark, the phenomenon such as poor transparency, is the main cause of the bad quality plastic caused by not fully dry before molding, engineering plastics such as PA, PET, PC, PBT, CA hygroscopicity strong materials, due to the internal water seep into the plastic particles, the traditional hot air drying machine is unable to make it completely dry.

3. The three-machine dehumidification and drying machine is in a closed circulation system to fully dehumidify the air heating, dry air will quickly plastic particles of water completely precipitation to achieve the effect of dehumidification and drying.